Select the Appropriate Coating
Low-E glazing falls into two broad categories: soft coat and hard coat. Both applications involve depositing a thin, transparent coating of silver or tin oxide on the glass surface to allow short-wavelength sunlight to pass through while blocking long-wavelength heat radiation. The difference between the two coatings lies in their application, which affects the glazing performance and durability.
Apply a Soft-Coat Glazing
Soft (or sputtered) coat is the most common type of low-E glazing. In this application, the layer of silver is deposited onto the glass through a sputtering process after the glass has been manufactured. Although it provides the best U-value available, this type of coating is fairly delicate and has to be protected within an insulated glass unit (IGU) to prevent scratching.
Or Apply a Hard-Coat Glazing
During the manufacturing process, a pyrolytic or hard-coat low-E glazing incorporates a thin layer of tin oxide into the glass while it is still hot. Applying the tin at this stage welds it to the glass, resulting in a durable coating. Hard-coat glazings can be used in single-glazed windows or storm doors, but their emissivity is not as low as that of soft-coat glazings. Because the glass has a higher solar heat gain coefficient (SHGC), it works well for houses that rely on passive solar heating.
Determine Glass Placement in Windows
The placement of the glass within a double-glazed or IGU window assembly will affect its U-factor, SHGC, and energy performance, which also depend on climate. In warmer climates, where it’s important to keep out unwanted heat, the preferred location for the low-E coating is the No. 2 surface (the inner face of the outer pane of glass), as it helps to minimize heat transfer into the home. In very cold climates, the low-E coating should be located on the No. 3 surface (the outer face of the inner pane of glass). Here, the coating is most effective in blocking heat loss while enabling beneficial solar heat gain. Once the appropriate location is determined, the treated glass may be cut and installed in the window assembly.